It works! As flat sticker, not a printed tile. Now removing dotted area makes sense
I tried it in Ldcad and it works too, but there are problems that are not in other stickers:
It does not "snap" to the plate. The Y position of sticker is -1 and 0 for tile. If the sticker position is on 0 then it is inside the tile and not clearly visible. Other stickers snap perfectly
The pattern is visible on the oppoiste side too, but mirrored. Not on other stickers
Please note that all 3 parts are on Y=0 position
I tried it in Ldcad and it works too, but there are problems that are not in other stickers:
It does not "snap" to the plate. The Y position of sticker is -1 and 0 for tile. If the sticker position is on 0 then it is inside the tile and not clearly visible. Other stickers snap perfectly
The pattern is visible on the oppoiste side too, but mirrored. Not on other stickers
Please note that all 3 parts are on Y=0 position