[Complete] Part Request: 31512pb01 Princess Morbucks headpiece

[Gerald Lasser]

Nice mockup! I might be able to help making your mockup one mesh in Blender. If that is wanted for the model. To avoid the intersections.

Thanks for the offer. 
Getting rid of the interceptions is not so much the issue using CSG in LDPE, though blender does it even better I imagine. 
I stepped countless times through a very good YT build video to get the locations of the ellipsoids and also views from top and bottom. Some still would still need the one or other "strech" /push applied. But without the phydical part this might be difficult/very time consuming.
I will add the edege lines for the intersections. 

... and i need a part number...