(2023-01-06, 6:31)tom alphin Wrote: Awesome, thanks! What you've done so far looks pretty realistic. I suspect this requires that you define a new "connection type" for the tube connection, since I think it is unique to these parts. As you likely saw in my article, there's also a horizontal hoop that can hold a vertical section of tube, and a "round door" that can hold a horizontal section of tube. Weird stuff!
The Tubes set is in storage because it's a frustrating product, but I can get them out. Yes, I have a pair of digital calipers!
Can you doodle on that image with the specific measurements you need?
Thanks to Philo's hint I could check my parts. I got the center line on point, but I am off with the diameter of the tubes, but that is a minor issue. The door I got spot on, so looks pretty good at this moment.
S all five parts are available:
31191 - Horizontal Holder
31193 - Door
31195 - Curve
42029 - Hoop
31452 - Straight Section