Ok, another semi related opinion poll...
When changing the 'selection center' (aka rotation center) in a current selection, should it reset back to the main part center for the next selection (a deselect in between) or should it live on for ever (or at least while the application runs).
Cause this kinda bugged me in mlcad (sometimes you moved it by mistake, without even noticing).
But it also might be irritating when it resets unwanted all the time as well. I would like to make this somewhat smart without resorting to jet another option, any ideas?
When changing the 'selection center' (aka rotation center) in a current selection, should it reset back to the main part center for the next selection (a deselect in between) or should it live on for ever (or at least while the application runs).
Cause this kinda bugged me in mlcad (sometimes you moved it by mistake, without even noticing).
But it also might be irritating when it resets unwanted all the time as well. I would like to make this somewhat smart without resorting to jet another option, any ideas?