Vulture droid printed wedge, #64225pb012, I've started if someone can take over


RE: Vulture droid printed wedge, #64225pb012, I've started if someone can take over
#3
(2022-12-08, 6:43)Kirby Wrote: Im trying to get this part into Studio for some rendering. Let me know if Im missing anything here. Thanks so much!!!

One thing to note is that Studio uses a different PNG-to-texture method than LDraw does, so you might get more targeted answers over in the Studio forums. And while LDraw does have a method for this also (called TEXMAP), this pattern is simple/geometric enough that we probably wouldn't use that (you'd just colorize the tri- and quadrangles directly into the part).

Another thing I notice (if using the Studio texture method) is that you've separated the side panel of the pattern (gray area) from the top panel part. Probably makes sense for Mecabricks, but I'm guessing Studio will want to see it as a single, connected area that it can wrap/project around the unpatterned part in Part Designer.

That said, this is a totally doable job for the wizards here at LDraw, and your preview image should help, so if you're not on a deadline I'm sure it can happen soon… ;-)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Vulture droid printed wedge, #64225pb012, I've started if someone can take over - by N. W. Perry - 2022-12-08, 14:59

Forum Jump:


Users browsing this thread: 3 Guest(s)