Here are a few things that I experienced using LDDP:
It crashes. I don't know what's causing it, but it happens from time to time when I click on the X to close it. It starts blinking and it can just be closed via the taskmanager.
Error List sometimes doesn't work. It gives an error message, something like "floating division by 0". Mostly when a pattern comes fresh out of LPC. When I checked it with DATHeader and have already corrected a lot of stuff, then the errorlist works.
I find the rotation buttons very confusing. They're not working as in MLCad although they're using almost the same symbols. If the arrow goes CCW the part should turn CCW.
It crashes. I don't know what's causing it, but it happens from time to time when I click on the X to close it. It starts blinking and it can just be closed via the taskmanager.
Error List sometimes doesn't work. It gives an error message, something like "floating division by 0". Mostly when a pattern comes fresh out of LPC. When I checked it with DATHeader and have already corrected a lot of stuff, then the errorlist works.
I find the rotation buttons very confusing. They're not working as in MLCad although they're using almost the same symbols. If the arrow goes CCW the part should turn CCW.