Hello,
I have a problem with LDCad 1.6d in Windows 11 where my rubber bands turn up "invisible".
All I can see is the projected path of where the rubberband is supposed to go.
Went into the "TEMPLATES" bin and selected the "Rubber band templates" sub bin.
In that bin I have 2 choices: Either round or square rubberband.
They are shown as identical round dotted lines in the bin.
I picked the one marked as round.
I selected a rubber color (red) and placed the band where I wanted it. No rubberband visible, just its path.
Switched editing mode to "NESTED", still no visible rubberband, just the projected path AND it's control handles.
You can see my issue in the picture below. It's taken while in "NORMAL" editing or "VIEW" mode... they look identical so doesn't matter which.
Am I not supposed to see the actual rubberband until I render it or am I missing something?
Thank you in advance for any help and / or advice!
Blake
I have a problem with LDCad 1.6d in Windows 11 where my rubber bands turn up "invisible".
All I can see is the projected path of where the rubberband is supposed to go.
Went into the "TEMPLATES" bin and selected the "Rubber band templates" sub bin.
In that bin I have 2 choices: Either round or square rubberband.
They are shown as identical round dotted lines in the bin.
I picked the one marked as round.
I selected a rubber color (red) and placed the band where I wanted it. No rubberband visible, just its path.
Switched editing mode to "NESTED", still no visible rubberband, just the projected path AND it's control handles.
You can see my issue in the picture below. It's taken while in "NORMAL" editing or "VIEW" mode... they look identical so doesn't matter which.
Am I not supposed to see the actual rubberband until I render it or am I missing something?
Thank you in advance for any help and / or advice!
Blake