2D (ortho) editing
2012-05-03, 20:19 (This post was last modified: 2012-05-12, 20:06 by Roland Melkert.)
2012-05-03, 20:19 (This post was last modified: 2012-05-12, 20:06 by Roland Melkert.)
Hi all, I've been working on LDCad's 2D (Ortho) editing mode on and off lately, and I'm almost ready with the basic view handling. Next on the to do list is to put in special editing tools for that mode.
I already have some ideas, but at this stage I could still implement something completely different if brought to my attention.
For starters it will have mlcad's way of selection handling (always in front rectangle), everything else is still open to suggestions.
So I was wondering if anyone else has some pointers/ideas concerning working in 2D mode? Especially from the people saying they hate 'those 3D only editors'
I already have some ideas, but at this stage I could still implement something completely different if brought to my attention.
For starters it will have mlcad's way of selection handling (always in front rectangle), everything else is still open to suggestions.
So I was wondering if anyone else has some pointers/ideas concerning working in 2D mode? Especially from the people saying they hate 'those 3D only editors'