RE: LDCad 1.7 Alpha 2 (win+linux)
2022-06-15, 1:26 (This post was last modified: 2022-06-15, 1:27 by David Manley. Edit Reason: typo )
2022-06-15, 1:26 (This post was last modified: 2022-06-15, 1:27 by David Manley. Edit Reason: typo )
A feature request rather than a bug.
It would be helpful to be able to filter a parts bin on the basis of parts not matching. For example, if I'm looking at the part bin "By Category/Brick", I'd like to see neither patterned nor stickered bricks. At the moment, I can filter to show parts containing "pattern" or "sticker" but not the opposite. A simple extension to the syntax, perhaps prefixing a symbol such as an exclamation mark (!) to the word being filtered, would enable this capability.
For example, while a filter of "pattern" would show patterned bricks, a filter of "!pattern" would exclude patterned bricks.
Regards,
David
It would be helpful to be able to filter a parts bin on the basis of parts not matching. For example, if I'm looking at the part bin "By Category/Brick", I'd like to see neither patterned nor stickered bricks. At the moment, I can filter to show parts containing "pattern" or "sticker" but not the opposite. A simple extension to the syntax, perhaps prefixing a symbol such as an exclamation mark (!) to the word being filtered, would enable this capability.
For example, while a filter of "pattern" would show patterned bricks, a filter of "!pattern" would exclude patterned bricks.
Regards,
David