LDraw.org Discussion Forums › LDraw Programs › LDraw File Processing and Conversion v
ROTSTEP questions

ROTSTEP questions


N. W. Perry Offline
LDraw.org Moderator ******
PTSubmit
Posts: 1,180
Threads: 84
Joined: Sep 2019
RE: ROTSTEP questions
#12
2022-06-12, 18:05
(2022-06-12, 17:21)Roland Melkert Wrote: Reviewing the code and the MLCad spec documentation I'm thinking REL and ADD are currently wrong in LDCad.

But there are comments (on REL) about not following the spec on purpose.

I would need to setup a decent test file using all variants in multiple configurations to compare with LPub (thinking that would be the most important thing).

Yes, I remember that LDCad's use of REL was adjusted to match LPub3D (this only affects the order of multiplication, I guess?). The tricky bit is, the MLCad spec is the only place I can find the expected output of any ROTSTEP commands; LPub3D's documentation seems to mention only that they support it.
Find
Reply
« Next Oldest | Next Newest »



Messages In This Thread
ROTSTEP questions - by Roland Melkert - 2016-04-21, 22:37
RE: ROTSTEP questions - by Milan Vančura - 2016-04-23, 15:15
RE: ROTSTEP questions - by Roland Melkert - 2016-04-23, 20:42
RE: ROTSTEP questions - by Travis Cobbs - 2016-04-24, 4:59
RE: ROTSTEP questions - by Roland Melkert - 2016-04-24, 19:21
RE: ROTSTEP questions - by Travis Cobbs - 2016-04-25, 2:48
RE: ROTSTEP questions - by Roland Melkert - 2016-04-25, 20:54
RE: ROTSTEP questions - by N. W. Perry - 2022-06-11, 2:28
RE: ROTSTEP questions - by Roland Melkert - 2022-06-11, 18:40
RE: ROTSTEP questions - by N. W. Perry - 2022-06-11, 21:08
RE: ROTSTEP questions - by Roland Melkert - 2022-06-12, 17:21
RE: ROTSTEP questions - by N. W. Perry - 2022-06-12, 18:05
RE: ROTSTEP questions - by Roland Melkert - 2022-06-16, 21:28
RE: ROTSTEP questions - by N. W. Perry - 2022-06-16, 23:27
RE: ROTSTEP questions - by Roland Melkert - 2022-06-17, 18:40
RE: ROTSTEP questions - by N. W. Perry - 2022-06-17, 21:22

Forum Jump:


Users browsing this thread: 11 Guest(s)