LDraw.org Discussion Forums › LDraw Programs › LDraw File Processing and Conversion v
STEP files into LDraw

STEP files into LDraw


Tim Gould Offline
LDraw.org Moderator ******
PTSubmit
Posts: 1,112
Threads: 85
Joined: Jul 2011
Re: STEP files into LDraw
#3
2012-04-26, 0:59
The best solution would be to write an auto-generator for plates of different sizes, using primitives. Basically you have corners, edges and interior parts so you could make any dimension using just three basic building blocks.

I'm sure Philo will have that written by tomorrow Wink

Tim
Find
Reply
« Next Oldest | Next Newest »



Messages In This Thread
STEP files into LDraw - by Dorota Sauer - 2012-04-25, 20:56
Re: STEP files into LDraw - by Rolf Osterthun - 2012-04-25, 21:59
Re: STEP files into LDraw - by Tim Gould - 2012-04-26, 0:59
Re: STEP files into LDraw - by Steffen - 2012-04-26, 1:05
Re: STEP files into LDraw - by Steffen - 2012-04-26, 1:19
Re: STEP files into LDraw - by Tim Gould - 2012-04-26, 5:16
Re: STEP files into LDraw - by Dorota Sauer - 2012-04-26, 15:09
Re: STEP files into LDraw - by Dorota Sauer - 2012-04-26, 21:04
Re: STEP files into LDraw - by Steffen - 2012-04-26, 21:46
Re: STEP files into LDraw - by Steffen - 2012-04-26, 22:46
Re: STEP files into LDraw - by Dorota Sauer - 2012-05-01, 8:03

Forum Jump:


Users browsing this thread: 1 Guest(s)