Nae...
The entire axlehole family is still in use.
Yellow prims; axlehole, axlehol4, axlehol5, axlehol6 are redesigned, still using the same name.
(This made it possible to correct the design without recycling all affected parts.)
Green prims; axlehol2, axlehol3, axlehol7, axlehol8, axlehol9, axleho10, axleend are not changed.
Should only be used as axle primitives. Not as axleholes. Never inverted.
New prims; axl5hol8 , axl5hol9 , axl5ho10 , axl5end, should be used when axlehole.dat isn't possible to use.
axlehole.dat has included edgelines around the hole. This prevents it from being used inside cylindrical, recessed holes.
axl2hole.dat and axl3hole.dat doesn't. You need to add the edge primitives.
axl4hole.dat has been "autocorrected" since it is using the axlehol6 primitive. (Your image show the old design.)
And yes, updated versions of the entire axl2hole family is now present at the Part Tracker.
The entire axlehole family is still in use.
Yellow prims; axlehole, axlehol4, axlehol5, axlehol6 are redesigned, still using the same name.
(This made it possible to correct the design without recycling all affected parts.)
Green prims; axlehol2, axlehol3, axlehol7, axlehol8, axlehol9, axleho10, axleend are not changed.
Should only be used as axle primitives. Not as axleholes. Never inverted.
New prims; axl5hol8 , axl5hol9 , axl5ho10 , axl5end, should be used when axlehole.dat isn't possible to use.
axlehole.dat has included edgelines around the hole. This prevents it from being used inside cylindrical, recessed holes.
axl2hole.dat and axl3hole.dat doesn't. You need to add the edge primitives.
axl4hole.dat has been "autocorrected" since it is using the axlehol6 primitive. (Your image show the old design.)
And yes, updated versions of the entire axl2hole family is now present at the Part Tracker.