Patterns on transparent parts: To BFC or not to BFC?
2012-04-18, 7:17 (This post was last modified: 2015-09-11, 7:28 by Philippe Hurbain.)
2012-04-18, 7:17 (This post was last modified: 2015-09-11, 7:28 by Philippe Hurbain.)
After talking to Philo, he said I should ask on the Forum about this matter.
Should I BFC a pattern on a transparent part? If it's not BFC'd and you hit BFC in LDView (with red/green turned off) the pattern stays visible on the backside of the part, if it's BFC's the Pattern is not visible. Anyway, POV-Ray doesn't make any difference. The pattern is visible on the bottom, if BFC'd or not. So from my point of view it doesn't make any difference.
But what do you experts think about it? I'll do as you say.
Should I BFC a pattern on a transparent part? If it's not BFC'd and you hit BFC in LDView (with red/green turned off) the pattern stays visible on the backside of the part, if it's BFC's the Pattern is not visible. Anyway, POV-Ray doesn't make any difference. The pattern is visible on the bottom, if BFC'd or not. So from my point of view it doesn't make any difference.
But what do you experts think about it? I'll do as you say.