Hello,I was repairing my crappy 15068px0 when I noticed that there are gaps in this part.
The subfiles don't match at the vertices 20 -4 -20, -20 -4 -20, -20 -16 20 and 20 -16 20 (aka the top corners) the 48\1-8cyli.dat don't match the s01, and inside the s01, the 48\1-8chrd.dat don't match the top corner either.
1 1 -20 24.9719 20 0 1 0 -40.97 0 0 0 0 -56.57 48\1-8chrd.dat
1 2 20 25 20 0 -1 0 -40.97 0 0 0 0 -56.57 48\1-8chrd.dat
1 4 20 24.972 20 0 -40 0 -28.9719 0 -28.9719 -40 0 40 48\1-8cyli.dat
I didn't check all the printed parts, but the problem is present on p01 for instance.
Should this part been reworked or should it be left like that ?
The subfiles don't match at the vertices 20 -4 -20, -20 -4 -20, -20 -16 20 and 20 -16 20 (aka the top corners) the 48\1-8cyli.dat don't match the s01, and inside the s01, the 48\1-8chrd.dat don't match the top corner either.
1 1 -20 24.9719 20 0 1 0 -40.97 0 0 0 0 -56.57 48\1-8chrd.dat
1 2 20 25 20 0 -1 0 -40.97 0 0 0 0 -56.57 48\1-8chrd.dat
1 4 20 24.972 20 0 -40 0 -28.9719 0 -28.9719 -40 0 40 48\1-8cyli.dat
I didn't check all the printed parts, but the problem is present on p01 for instance.
Should this part been reworked or should it be left like that ?