(2021-08-03, 22:01)Roland Melkert Wrote: Yes just move all the sub parts around until the desired part center is at 0,0,0
But you will need a 'real' LDraw part editor as LDCad only allows editing of the shadow data.
I'm using Stud.io Part Designer, not sure if it is a 'real' editor.
And I was able to define the part center by placing the part at 0,0,0. Thank you.
This is getting to be an addition (part 65578 was driving me nuts!). How can I contribute to the official LDCad shadow library?
Also can you clarify for me please: for my unofficial parts library, I had no file or folder configured for the shadow library. So where did LDCad saved my shadow files?