RE: Improve parts with artefacts/ slowly rendering
2021-08-03, 23:59 (This post was last modified: 2021-08-04, 0:13 by Johannes Ahlmann.)
2021-08-03, 23:59 (This post was last modified: 2021-08-04, 0:13 by Johannes Ahlmann.)
OK, thank you for sharing!
I will have a look whether there are other importers that do better smoothing, but since this is coming from the geometry it seems to me that there is a small minority of parts that are causing these kinds of issues, while the vast majority render flawlessly.
I will also try "normal" resolution instead of "high" whether that makes a difference.
Are you aware of somewhere where I can raise these kinds of issues in a structured way, or is this simply not of interest?
I also believe that Mecabrick have high-resolution parts, I wonder if I could use their geometry for the few ones that are causing issues.
Best Regards,
Johannes
I will have a look whether there are other importers that do better smoothing, but since this is coming from the geometry it seems to me that there is a small minority of parts that are causing these kinds of issues, while the vast majority render flawlessly.
I will also try "normal" resolution instead of "high" whether that makes a difference.
Are you aware of somewhere where I can raise these kinds of issues in a structured way, or is this simply not of interest?
I also believe that Mecabrick have high-resolution parts, I wonder if I could use their geometry for the few ones that are causing issues.
Best Regards,
Johannes