looking for Bricklink part bb0219
2021-06-18, 10:21
(This post was last modified: 2023-07-07, 16:21 by Gerald Lasser.)
2021-06-18, 10:21
(This post was last modified: 2023-07-07, 16:21 by Gerald Lasser.)
Hi,
I installed the latest ‘Complete’ library (Parts update 2020-03) and was looking for the following piece:
https://www.bricklink.com/v2/catalog/cat...9#T=C&C=85
But can’t find it back in the ‘MLCad – Other Parts\B’ folder, so I guess it’s not yet available in the official library or even not in the Non official parts list on LDraw.org.
Question is, if I want to create this part how should this part be named?
It’s a part that I use for my train wagons in use with the sealed magnet.
So far it’s the only use I found to use this ‘bar / pin’, because the bottom ‘ring’ is too small for a tight fit between 4 studs like you can do with an antenna.
see picture in following link for the principe I use.
https://www.flickr.com/photos/[email protected]/
best regards,
Ludo
I installed the latest ‘Complete’ library (Parts update 2020-03) and was looking for the following piece:
https://www.bricklink.com/v2/catalog/cat...9#T=C&C=85
But can’t find it back in the ‘MLCad – Other Parts\B’ folder, so I guess it’s not yet available in the official library or even not in the Non official parts list on LDraw.org.
Question is, if I want to create this part how should this part be named?
It’s a part that I use for my train wagons in use with the sealed magnet.
So far it’s the only use I found to use this ‘bar / pin’, because the bottom ‘ring’ is too small for a tight fit between 4 studs like you can do with an antenna.
see picture in following link for the principe I use.
https://www.flickr.com/photos/[email protected]/
best regards,
Ludo