Best Practices

[Gerald Lasser]

Hello,

While these details are necessary for 3D print, doing this way the file will end up much too details.

We usually use a circle of 48 divisions for this size.

So as an approximation with existing Primitives that would end up as:

0 BFC INVERTNEXT
1 14 0 0 0 45.75 0 0 0 14.8 0 0 0 45.75 48\4-4cylo.dat
1 14 0 0 0 2.54167 0 0 0 1 0 0 0 2.54167 48\4-4rin18.dat
1 14 0 0 0 48.29173 0 0 0 1 0 0 0 48.29173 48\4-4edge.dat
1 14 0 12.8 0 1.17785 0 0 0 -12.8 0 0 0 1.17785 48\4-4con41.dat
1 14 0 12.8 0 49.46958 0 0 0 1 0 0 0 49.46958 48\4-4edge.dat

1 14 0 15.5 0 8.24493 0 0 0 -2.7 0 0 0 8.24493 48\1-4con6.dat
1 14 0 15.5 0 8.24493 0 0 0 -2.7 0 0 0 -8.24493 48\1-4con6.dat
1 14 0 15.5 0 -8.24493 0 0 0 -2.7 0 0 0 8.24493 48\1-4con6.dat
1 14 0 15.5 0 -8.24493 0 0 0 -2.7 0 0 0 -8.24493 48\1-4con6.dat

1 14 0 15.5 0 57.71451 0 0 0 2.74 0 0 0 57.71451 48\4-4cylo.dat


Gerald