So I tested my file "700-1-1 - Automatic Binding Bricks.mpd" and LDInspector found that the filename does not conform to the OMR standard because it doesn't match the set number + optional qualifier rule. In fact, the set number is "700-1" and the qualifier is "-1", so it should pass. Presumably the checker is confused by the extra hyphen.
(Actually the set number should be 700/1, but slashes mustn't appear in filenames. And 700.1 results in the same error message, probably for a similar reason.)
This is admittedly a fringe case, as there are not a whole lot of official models that will have slashes in their set numbers to begin with! But perhaps of interest as a mere curiosity.
(Actually the set number should be 700/1, but slashes mustn't appear in filenames. And 700.1 results in the same error message, probably for a similar reason.)
This is admittedly a fringe case, as there are not a whole lot of official models that will have slashes in their set numbers to begin with! But perhaps of interest as a mere curiosity.