62712 - Brick 2 x 2 with Ball Socket and Axlehole
2012-03-29, 20:24 (This post was last modified: 2012-03-30, 6:59 by Jude Parrill.)
2012-03-29, 20:24 (This post was last modified: 2012-03-30, 6:59 by Jude Parrill.)
Howdy,
I'm in the process of creating a highly-anticipated instructional guide of one of my recent custom creations -- however, I searched every possible part in the LDraw library for my software, and couldn't find one particular piece which is extremely vital to making the 3-D instructions: a 2x2 brick with a socket for a ball joint:
http://www.ldraw.org/cgi-bin/ptdetail.cg.../62712.dat
http://www.peeron.com/inv/parts/62712
After searching this site for information on it, I found and downloaded the DAT file from the first link, but I wasn't sure where to install it in the parts library folder (I mean, which particular folder). All I need is this piece for finishing my 3-D instructional guide; could one of the admins please review and certify this -- or at least, please instruct me how to install an unofficial DAT file of it to my library? Either or will be greatly appreciated! Thank you.
-Baron
I'm in the process of creating a highly-anticipated instructional guide of one of my recent custom creations -- however, I searched every possible part in the LDraw library for my software, and couldn't find one particular piece which is extremely vital to making the 3-D instructions: a 2x2 brick with a socket for a ball joint:
http://www.ldraw.org/cgi-bin/ptdetail.cg.../62712.dat
http://www.peeron.com/inv/parts/62712
After searching this site for information on it, I found and downloaded the DAT file from the first link, but I wasn't sure where to install it in the parts library folder (I mean, which particular folder). All I need is this piece for finishing my 3-D instructional guide; could one of the admins please review and certify this -- or at least, please instruct me how to install an unofficial DAT file of it to my library? Either or will be greatly appreciated! Thank you.
-Baron