(2021-03-29, 1:42)Travis Cobbs Wrote: I just ran a quick test. I created an LDR file that just had a reference to 2926.dat and nothing else, then did an LGEO export from LDView with LGEO enabled, and it used the LGEO hollow studs (with rounded edges and the LEGO logo). I'm pretty sure I'm using the last official LGEO release from Lutz Uhlmann, not one of the updates done by others.
As an aside, I think that adding an entry for stud2.dat that is just like the stud.dat one, but with lg_tech_knob and lg_tech_knob_clear would allow LDView to use the LGEO hollow studs on non-LGEO parts.
Thank you.
So I must have modified something on my old computer.
My test part was 1x2 jumper 15573.dat, so I checked with 3794b.dat and it doesn't use LGEO too.
I noticed right now that 3794b.dat is in LGEO.xml but defined as 3794.dat. I think I modified this entry at the time. Bad test part choice for me...
I added the stud2 entry with lg_teck_knob and it worked fine with 15573.dat. I'll see on other parts.
Thank you again.