Creating patterns from official instructions
(2020-10-18, 6:36)N. W. Perry Wrote: Well, for some reason I couldn't open the file in svg2ldraw at all. (The error message given is "Unsupported path command 'e'. The path will be skipped.")Yeah, even more than poor triangulation, partial support of svg is the problem of svg2ldraw (or svg2dat). Looks like full svg support is an unwieldy task
| Messages In This Thread |
|
Creating patterns from official instructions - by N. W. Perry - 2020-10-16, 16:33
RE: Creating patterns from official instructions - by Philippe Hurbain - 2020-10-16, 18:03
RE: Creating patterns from official instructions - by N. W. Perry - 2020-10-16, 18:33
RE: Creating patterns from official instructions - by N. W. Perry - 2020-10-18, 6:36
RE: Creating patterns from official instructions - by Philippe Hurbain - 2020-10-18, 7:02
RE: Creating patterns from official instructions - by N. W. Perry - 2020-10-18, 13:54
|
