Possible new primitive idea
2020-10-13, 3:59
(This post was last modified: 2020-10-13, 4:16 by Mark Kennedy.)
2020-10-13, 3:59
(This post was last modified: 2020-10-13, 4:16 by Mark Kennedy.)
Here is an idea for a possible new primitive that could be useful for plates like parts 2540, 48336, and quite a few others.
As for a name or description for such a primitive I would like some suggestions. There already exist a knob1 primitive used in minifig arms so should something else be used?
Another question I have is if the primitive should have holes where the cylinder enters it. This would possibly make 2 versions necessary, one with a hole on one side and another with holes on both [color=#333333][size=small][font=Tahoma, Verdana, Arial, sans-serif]sides.[/font][/size][/color]
[color=#333333][size=small][font=Tahoma, Verdana, Arial, sans-serif]Also the part makes use of a new 11-16disc [color=#333333][size=small][font=Tahoma, Verdana, Arial, sans-serif]primitive.[/font][/size][/color][/font][/size][/color]
As for a name or description for such a primitive I would like some suggestions. There already exist a knob1 primitive used in minifig arms so should something else be used?
Another question I have is if the primitive should have holes where the cylinder enters it. This would possibly make 2 versions necessary, one with a hole on one side and another with holes on both [color=#333333][size=small][font=Tahoma, Verdana, Arial, sans-serif]sides.[/font][/size][/color]
[color=#333333][size=small][font=Tahoma, Verdana, Arial, sans-serif]Also the part makes use of a new 11-16disc [color=#333333][size=small][font=Tahoma, Verdana, Arial, sans-serif]primitive.[/font][/size][/color][/font][/size][/color]