Request on part 6089

[Gerald Lasser]

I was actually thinking of these:


Just inverted half-cylinders (with a spherical end), I think? Can't quite make it out from photos.

Also, is the top of the stud2 flush with the rim of the dish? Or is it actually recessed a bit, as in the LDD mesh?

Ah, yes, now I understood, a picture is worth a thousand words :-)

This is in my opinion a molding artifact. The hollow stud is terminated with a smaller hole (smaller than 4 LDU) and this extends a bit further into the part and interestingly around the corner. I guess as the plastic cooled down this was pulled "inside" I should have another one as well to verify how this looks in different parts.

So no, it is not a ridge, the part is as the LDD data shows, a normal bar diameter.