RE: Request on part 6919
2020-10-08, 16:09 (This post was last modified: 2020-10-08, 16:15 by Gerald Lasser.)
2020-10-08, 16:09 (This post was last modified: 2020-10-08, 16:15 by Gerald Lasser.)
(2020-10-08, 13:20)N. W. Perry Wrote: Looks great, thanks!
Yes, the LDD mesh is pretty close already. At first I thought the rim of the dish was a little too thick, but from your photos it looks OK.
Are those grooves just basically hollow half-cylinders? (And they are grooves, right—not ridges?)
I started authoring it already, I made them like this, which represents them very accurate
1 16 0 0 0 4 0 0 0 22.7 0 0 0 4 4-4cylc.dat
1 16 0 23.45 0 2 0 0 0 -.75 0 0 0 2 4-4con2.dat
1 16 0 23.45 0 6 0 0 0 2 0 0 0 6 4-4cylo.dat
1 16 0 25.45 0 2 0 0 0 .75 0 0 0 2 4-4con2.dat
1 16 0 26.2 0 4 0 0 0 1 0 0 0 4 4-4cylo.dat
1 16 0 27.95 0 2 0 0 0 -.75 0 0 0 2 4-4con2.dat
1 16 0 27.95 0 6 0 0 0 2 0 0 0 6 4-4cylo.dat
1 16 0 29.95 0 2 0 0 0 .75 0 0 0 2 4-4con2.dat
1 16 0 30.7 0 4 0 0 0 1 0 0 0 4 4-4cylo.dat
1 16 0 32.45 0 2 0 0 0 -.75 0 0 0 2 4-4con2.dat
1 16 0 32.45 0 6 0 0 0 2 0 0 0 6 4-4cylo.dat
1 16 0 34.45 0 2 0 0 0 .75 0 0 0 2 4-4con2.dat
Feel free to go ahead!