(2020-10-08, 7:30)Gerald Lasser Wrote: Found it! Here you are
https://www.dropbox.com/sh/uma9e1wx3dfx4...f2Wma?dl=0
Basic geometry from LDD looks ok, even for the dish itself, cutouts ar in the pictures!
Note that the Dish geometry is different from the usual 2x2 Dish and this part has a stud2 in the center!
Looks great, thanks!
Yes, the LDD mesh is pretty close already. At first I thought the rim of the dish was a little too thick, but from your photos it looks OK.
Are those grooves just basically hollow half-cylinders? (And they are grooves, right—not ridges?)