BEAD004 From Lego Pens

[SNIPE]

Hi,

Thanks for the code.

The hole and inner tube is now correct however the bottom has no face on it and also theres lines on the inside of the bar hole for some reason:



Here is the updated file, I don't know if I made a mistake or not, This is literally my first time making an LDRAW part and its tough!
1 16 0 4 0 1 0 0 0 -6.5 0 0 0 1 stud4a.dat

0 BFC INVERTNEXT
1 16 0 30 0 12 0 0 0 -26 0 0 0 12 box4.dat
1 16 0 4 0 8 0 0 0 -1 0 0 0 8 4-4ndis.dat
4 16 -12 4 -12 -12 4 12 -8 4 8 -8 4 -8
4 16 -12 4 -12 -8 4 -8 8 4 -8 12 4 -12
4 16 12 4 -12 8 4 -8 8 4 8 12 4 12
4 16 -12 4 12 12 4 12 8 4 8 -8 4 8

1 16 0 30 0 15 0 0 0 -30 0 0 0 15 box4.dat
1 16 0 0 0 6 0 0 0 1 0 0 0 6 4-4ndis.dat
4 16 -6 0 6 6 0 6 15 0 15 -15 0 15
4 16 -6 0 6 -15 0 15 -15 0 -15 -6 0 -6
4 16 -6 0 -6 -15 0 -15 15 0 -15 6 0 -6
4 16 6 0 -6 15 0 -15 15 0 15 6 0 6

1 16 0 0 0 1 0 0 0 1 0 0 0 1 stud2.dat
1 16 0 0 0 6 0 0 0 1 0 0 0 6 4-4edge.dat

0 BFC INVERTNEXT
1 16 0 0 0 4 0 0 0 4 0 0 0 4 4-4cyli.dat
1 16 0 4 0 4 0 0 0 1 0 0 0 4 4-4edge.dat
1 16 0 4 0 2 0 0 0 -1 0 0 0 2 4-4ring2.dat


Regards, Snipe.