Hi,
I need help finishing my implementation of part BEAD004, I need the stud to be fully hollow so a bar can go right through it and also the bottom tube is intersecting the top wall of the brick slightly.
Here is my code so far:
4 16 -15 30 -15 -15 0 -15 15 0 -15 15 30 -15
4 16 15 30 -15 12 30 -12 -12 30 -12 -15 30 -15
4 16 15 30 15 12 30 12 12 30 -12 15 30 -15
4 16 -15 30 15 -12 30 12 12 30 12 15 30 15
4 16 -15 30 -15 -12 30 -12 -12 30 12 -15 30 15
0
1 16 0 1 0 1 0 0 0 -7.25 0 0 0 1 stud4.dat
1 16 0 30 0 15 0 0 0 -30 0 0 0 15 box4t.dat
0 BFC INVERTNEXT
1 16 0 30 0 12 0 0 0 -26 0 0 0 12 box5.dat
1 16 0 0 0 1 0 0 0 1 0 0 0 1 stud2.dat
Here are some references to the parts design:
https://youtu.be/eiegAdgSpcg?t=481
https://www.bricklink.com/v2/catalog/cat...ead004#T=C
There is also a load of other beads that are super useful that I would like to see but thats maybe for a seperate thread, and they are too complex for a beginner like me to make in LDRAW.
Regards, Snipe.
I need help finishing my implementation of part BEAD004, I need the stud to be fully hollow so a bar can go right through it and also the bottom tube is intersecting the top wall of the brick slightly.
Here is my code so far:
4 16 -15 30 -15 -15 0 -15 15 0 -15 15 30 -15
4 16 15 30 -15 12 30 -12 -12 30 -12 -15 30 -15
4 16 15 30 15 12 30 12 12 30 -12 15 30 -15
4 16 -15 30 15 -12 30 12 12 30 12 15 30 15
4 16 -15 30 -15 -12 30 -12 -12 30 12 -15 30 15
0
1 16 0 1 0 1 0 0 0 -7.25 0 0 0 1 stud4.dat
1 16 0 30 0 15 0 0 0 -30 0 0 0 15 box4t.dat
0 BFC INVERTNEXT
1 16 0 30 0 12 0 0 0 -26 0 0 0 12 box5.dat
1 16 0 0 0 1 0 0 0 1 0 0 0 1 stud2.dat
Here are some references to the parts design:
https://youtu.be/eiegAdgSpcg?t=481
https://www.bricklink.com/v2/catalog/cat...ead004#T=C
There is also a load of other beads that are super useful that I would like to see but thats maybe for a seperate thread, and they are too complex for a beginner like me to make in LDRAW.
Regards, Snipe.