Hello, I'm not sure if this is a stupid question, but I haven't been able to find an answer in the documentation.
I came across the subfile box2-7.dat in the basepart 3289s01.dat. In the file, the box is used for the backside of the slope. What I
don't understand is how the angle of the subfile changes form 90 degree to a different angle. As far as I understand can the transfomation
matrix only affect the rotation, position and scaling of the subfile.
Here is the box2-7 subfile. As you can see, the angle between the two quads is 90 degree.
![[Image: dWuFliZ.png]](https://i.imgur.com/dWuFliZ.png)
And here is how the box2-7 subfile look in 3289s01.dat. The angle between the two quads is different as well as the dimensions.
![[Image: zoILfQ9.png]](https://i.imgur.com/zoILfQ9.png)
I changed the position so it is easier to see. Where in the files does the geometry change?
I came across the subfile box2-7.dat in the basepart 3289s01.dat. In the file, the box is used for the backside of the slope. What I
don't understand is how the angle of the subfile changes form 90 degree to a different angle. As far as I understand can the transfomation
matrix only affect the rotation, position and scaling of the subfile.
Here is the box2-7 subfile. As you can see, the angle between the two quads is 90 degree.
And here is how the box2-7 subfile look in 3289s01.dat. The angle between the two quads is different as well as the dimensions.
I changed the position so it is easier to see. Where in the files does the geometry change?