30116pb03, Panel 14x14x2.667 with Millennium Falcon Pattern

[Daniel Goerner]

Very good job indeed!

Edger2 says the subfile is okay

Well... not quite, I see 4 red lines that at closer look are caused by needle shaped gaps.

That must have happened after I used Slicerpro. Before using it everything was alright.

And LDDP does report a few errors (see below).
[...]
Most can be split into appropriate triangles to solve the problem .
As for the header, I suggest the use of Datheader... that will not only correct headers issues (missing space in front of 2.667, ö of your name converted to UTF8) but also most of previous problems (only 2 very thin triangles remain).

I now used Datheader on the original Patterm, before projecting it. 6 Errors remain:

Code:

Line 87: Colinear vertices found. 4 6 23.86372 0 -160.7092 48.374 0 -174.727 47.547 0 -171.369 46.777 0 -168.254
Line 163: Colinear vertices found. 4 7 61.97413 0 -149.1488 58.005 0 -148.344 52.601 0 -149.846 49.571 0 -150.693
Line 338: Colinear vertices found. 4 4 185.594 0 -132.186 186.593 0 -132.767 186.164 0 -130.557 180.756 0 -129.366
Line 560: Colinear vertices found. 4 6 205.928 0 -72.879 205.147 0 -75.71 204.9948 0 -85.519 207.471 0 -67.309
Line 618: Colinear vertices found. 4 7 279.7504 0 -40.89976 277.239 0 -43.509 275.819 0 -48.649 275.184 0 -50.951
Line 754: Colinear vertices found. 3 1 149.974 0 -62.301 192.2205 0 -81.11035 193.076 0 -81.47137

I don't know what this means (like the stuff you posted, remember, I never did this before). I think there are vertexes placed on top of each other. But I don't know how to find, correct or eliminate them.

How did you do projection on surface? Using Slicerpro? then maybe playing a bit with "precision" and/or unification thresholds would have eliminated some of the issues from the start?

Yes, i used Slicerpro. Very cool tool. I made the part with stickers (using Sticker Generator) before and it was torture to place them right. I'll try to play around with the settings tomorrow.