(2020-07-02, 13:19)Gerald Lasser Wrote: IMHO concerning the part naming when it comes to dimensions, e.g. if it is 2 plates high, it will be .667, this was change in the past from 2/3 to this, I think it should be added and also how many decimals shall there be in the description (3).
An example has been added to the header spec.
(2020-07-02, 13:19)Gerald Lasser Wrote: Also:
anything Bricklike: Studs x Studs x Bricks
anything Technic looking: Studs x Studs x Studs
Hmm. Header spec or Official Library spec?
(2020-07-02, 13:19)Gerald Lasser Wrote: Where is the orientation of a part taken care of?
Nowhere. Origin and orientation could be a document in and of itself.
I added some verbiage here:
https://www.ldraw.org/article/512draft.html#origin
I think it's better to write in general terms and let the individual cases be sorted out on the PT but I'm open to rewrite suggestions.