RE: Official Library File Format Restictions
2020-07-02, 13:19 (This post was last modified: 2020-07-02, 13:34 by Gerald Lasser.)
2020-07-02, 13:19 (This post was last modified: 2020-07-02, 13:34 by Gerald Lasser.)
IMHO concerning the part naming when it comes to dimensions, e.g. if it is 2 plates high, it will be .667, this was change in the past from 2/3 to this, I think it should be added and also how many decimals shall there be in the description (3).
Also:
anything Bricklike: Studs x Studs x Bricks
anything Technic looking: Studs x Studs x Studs
Where is the orientation of a part taken care of?
Also:
anything Bricklike: Studs x Studs x Bricks
anything Technic looking: Studs x Studs x Studs
Where is the orientation of a part taken care of?