(2020-06-09, 8:06)Philippe Hurbain Wrote: Yes, that's the tool I would use. Use the front of windscreen as former, and make the pattern from there. Since the curvature is high, probably needs to make it in (at least 3, perhaps 4) sections at from several directions. Junctions can be a nightmare... And this pattern is not even symmetrical
Yes, and the pattern is at an angle with respect to the part, because it attaches at a vertical angle, but the arch is supposed to match the angle of the legs (just short of 34°).
Regarding the symmetry, I can't tell if it's supposed to be, and the printing layers are just offset (a common issue), in which case perhaps you could do the light and dark gray as two mirrored halves, then add the black shading afterward (which is asymmetrical in any case)?