(2020-06-01, 16:34)Magnus Forsberg Wrote: How do you make parts with LDDP? I've never done that.
Do you have the points in the right order?
Start Point (10.7 0 0)
Control Point 1 (70.2 0 0)
Control Point 2 (-1.3248 -14.3041 0)
End Point (53.6532 8.4844 0)
I'm also not familiar with that process; opening this file in LDDP and selecting the bendable part menu option didn't reveal anything.
I do note that the fifth segment (excluding the end caps) is rotated 180° with respect to the others in the Y direction. Rotating that didn't immediately change anything as far as I could see, but perhaps it indicates an orientation problem with one of the control points?