RE: 25195 Plate, Modified 2 x 6 with Pole Holder Pin
2020-04-16, 9:22 (This post was last modified: 2020-04-16, 9:22 by Magnus Forsberg.)
2020-04-16, 9:22 (This post was last modified: 2020-04-16, 9:22 by Magnus Forsberg.)
OK, great.
Here is a preview, of what I see on the images.
25195.dat (Size: 15.19 KB / Downloads: 6)
Is the height of the cylinder correct? I can't tell that from your images.
IMO the inside of the "handle with bars", 23422.dat , is too narrow. Don't think it is the same as a stud.
That upside down 1x1 brick didn't stick when you placed it on top of the cylinder. Right?
Here is a preview, of what I see on the images.
25195.dat (Size: 15.19 KB / Downloads: 6)
Is the height of the cylinder correct? I can't tell that from your images.
IMO the inside of the "handle with bars", 23422.dat , is too narrow. Don't think it is the same as a stud.
That upside down 1x1 brick didn't stick when you placed it on top of the cylinder. Right?