RE: 25195 Plate, Modified 2 x 6 with Pole Holder Pin
2020-04-15, 19:11 (This post was last modified: 2020-04-15, 19:14 by Lasse Deleuran.)
2020-04-15, 19:11 (This post was last modified: 2020-04-15, 19:14 by Lasse Deleuran.)
I have uploaded raw images to imgur. https://imgur.com/a/Jv6MaUz
See some samples below.
These show the part in yellow with closeups of the hole. The pin 1/2 is used to show the debt of the hole from both sides, while the 1 x 1 brick shows that the width of the cylinder from the outside is 8mm. The crossaxle shows that the internal diameter is a bit smaller than the typical pin hole. The top view should be good enough for an accurate measurement.
![[Image: 7Whbyrh.jpg]](https://i.imgur.com/7Whbyrh.jpg)
![[Image: ikogGbw.jpg]](https://i.imgur.com/ikogGbw.jpg)
![[Image: Nn0yLvp.jpg]](https://i.imgur.com/Nn0yLvp.jpg)
Please tell me when you have the LDraw part ready - then I can run a review on it.
See some samples below.
These show the part in yellow with closeups of the hole. The pin 1/2 is used to show the debt of the hole from both sides, while the 1 x 1 brick shows that the width of the cylinder from the outside is 8mm. The crossaxle shows that the internal diameter is a bit smaller than the typical pin hole. The top view should be good enough for an accurate measurement.
Please tell me when you have the LDraw part ready - then I can run a review on it.