(2020-04-13, 11:38)Chad Voller Wrote: Ok, N. W. Perry's solution worked out for me! After removing "parts\" from the end of the path, closing the program, and reopening, the parts are now fully formed!
Thanks, this is a huge step for us rookies in using LDCad!
Did you use the AIOI to install LDCad?
If so there might be a problem with it as it should have set the parts folder for LDCad automatically.
Or did you get the 'select LDraw folder' dialog at first start up?
If that was the case it should have complained about that location not being a valid LDraw location if it didn't there might be a bug at play.