(2019-12-10, 19:49)Philippe Hurbain Wrote: I had a close look at this problem. Parts are not awefully wrong, most of the issue seems indeed to come from rotation point position. If we raise it by 1.5 ldu, it comes out pretty good, we reach 175°, which seems to match well the part I have here (no, I can't reach 180° without stressing the stick - maybe yours is more used and has a little play?). I propose to create a c02 assembly shortcut with raised stick, and obsoletize current c01. Of course connectivity should be corrected too. Opinions?
I can't directly observe the real part right now, but I think the exact amount of travel depends on variations in the actual physical tolerance, and probably also the stiffness of the joint, due to age, wear and mold variations. (I do believe there were two mold versions of this part, differing in the size of the rotational disc.)
I would agree that just adjusting the "official" positioning of the parts, along with the connectivity, is probably adequate.