Hi Philip,
It's great to see you using the LDraw Pattern Creator (LPC) program. Based on your experience so far it would be great if you were able to put some short instructions together on the process you used to construct the part using LPC. This could then be used to improve the current online documentation for the program. Feel free to send over instructions/screenshots and I'll try and formalise this into some form of user documentation.
Reuben
[email protected]
It's great to see you using the LDraw Pattern Creator (LPC) program. Based on your experience so far it would be great if you were able to put some short instructions together on the process you used to construct the part using LPC. This could then be used to improve the current online documentation for the program. Feel free to send over instructions/screenshots and I'll try and formalise this into some form of user documentation.
Reuben
[email protected]