So I managed to create a template (i think).
This is the end result as rendered in Stud.io.
The design seems to be not the black selected in LDPC and it also seems to show the triangles created in LDPC.
Was i Supposed to offset the pattern at some point to get it to sit on the surface of the brick rather than within the surface?
This is the end result as rendered in Stud.io.
The design seems to be not the black selected in LDPC and it also seems to show the triangles created in LDPC.
Was i Supposed to offset the pattern at some point to get it to sit on the surface of the brick rather than within the surface?