LD Pattern Creator Help - Template creation
2019-09-10, 22:52 (This post was last modified: 2019-09-10, 22:53 by ShireBrickz.com.)
2019-09-10, 22:52 (This post was last modified: 2019-09-10, 22:53 by ShireBrickz.com.)
Hi LD community.
I’m after some help with either understanding the process of importing .dat files into LD Pattern Creator, or creating additional templates.
I’ve used the software for a while now and can create patterns using the supplied templates, but can’t seem to successfully create pieces which are not already supplied. Are there any suggested posts or instructions elsewhere to explain the process of importing existing .dat files from the LDRaw Parts Library and selecting the correct face. For example I can’t successfully find the large face of 1x6x5 panel (59349) to then create my pattern.
Thanks in advance
Adam
I’m after some help with either understanding the process of importing .dat files into LD Pattern Creator, or creating additional templates.
I’ve used the software for a while now and can create patterns using the supplied templates, but can’t seem to successfully create pieces which are not already supplied. Are there any suggested posts or instructions elsewhere to explain the process of importing existing .dat files from the LDRaw Parts Library and selecting the correct face. For example I can’t successfully find the large face of 1x6x5 panel (59349) to then create my pattern.
Thanks in advance
Adam