(2019-07-30, 9:30)Vincent Messenet Wrote: Welcome Matt!Hi Vincent,
I'm a Mac user too and also swiched from both Bricksmith and LDD to Studio to build models and render but mainly use LD Part Editor to design parts. I also recently started to use Img4Dat to generate some parts before cleaning them in LDPE. I am running Img4Dat on Windows using Parallel.
Cheers
| Messages In This Thread |
|
New member checking in - by Matt Walker - 2019-07-29, 22:51
RE: New member checking in - by Orion Pobursky - 2019-07-29, 23:26
RE: New member checking in - by Matt Walker - 2019-07-29, 23:57
RE: New member checking in - by Vincent Messenet - 2019-07-30, 9:30
RE: New member checking in - by Matt Walker - 2019-07-30, 12:04
RE: New member checking in - by Philippe Hurbain - 2019-07-30, 13:38
RE: New member checking in - by Vincent Messenet - 2019-07-30, 19:23
RE: New member checking in - by Matt Walker - 2019-07-31, 2:06
RE: New member checking in - by N. W. Perry - 2019-09-07, 3:49
RE: New member checking in - by Philippe Hurbain - 2019-09-07, 6:41
RE: New member checking in - by N. W. Perry - 2019-09-09, 13:57
|
