BFC and parts

[Michael Horvath]

Not really. It's super easy:

- Add BFC CERTIFY CCW per the header spec
- Open the part in LDView
- In Preferences -> BFC, check the "green front faces" and "red back faces" options and click apply
- Look for any red
- If it's a tri/quad, reverse the winding
- If it's flat primitive, flip it 180
- If it's a non-flat primitive, put BFC INVERTNEXT before it
- Continue until there is no red

I tried this, but it involves a lot of guesswork figuring out which line represents which surface.

I tried the program LD Part Editor instead, but not all sub-parts/primitives are rendered for some reason. There is just empty space where some sub-parts/primitives are supposed to be. (Most Some of them seem to function properly however.)