Thanks for the answers, Willy.
I forgot all about searching for these answers in lugnet since I started back up with LDraw this winter!!!
That last post is quite the eye-opener.
I have to say, a strict, or nit-picking review is discouraging. Especially in the grey areas where the standard can not be used to mediate (sub-parts). The community should be happy people are still out here modelling, and not make this hobby painful. It's not a job!!!
I'll try just using a box for the back and see. I do think a 2 LDU radius isn't worth the overhead of pulling in the 1/4 cylinders, chords and discs, but I didn't want to be wrong.
With all the drive toward accuracy, I would think rounded corners, and white sides/back for white sticker sheets would be the preference!!! And looking at parts like the 1 x 1 plate w/ tooth, there's an edge line right down the middle of it, and it's not even a sharp edge!!!
I forgot all about searching for these answers in lugnet since I started back up with LDraw this winter!!!
That last post is quite the eye-opener.
I have to say, a strict, or nit-picking review is discouraging. Especially in the grey areas where the standard can not be used to mediate (sub-parts). The community should be happy people are still out here modelling, and not make this hobby painful. It's not a job!!!
I'll try just using a box for the back and see. I do think a 2 LDU radius isn't worth the overhead of pulling in the 1/4 cylinders, chords and discs, but I didn't want to be wrong.
With all the drive toward accuracy, I would think rounded corners, and white sides/back for white sticker sheets would be the preference!!! And looking at parts like the 1 x 1 plate w/ tooth, there's an edge line right down the middle of it, and it's not even a sharp edge!!!
- Greg
"The only stupid question is the one that remains unasked"
"The only stupid question is the one that remains unasked"