RE: What requires a HOLD vote on the Parts Tracker
2019-06-25, 18:28 (This post was last modified: 2019-06-25, 18:30 by Roland Melkert.)
2019-06-25, 18:28 (This post was last modified: 2019-06-25, 18:30 by Roland Melkert.)
(2019-06-25, 17:55)Orion Pobursky Wrote: Ok, but take this part for example:
https://www.ldraw.org/cgi-bin/ptdetail.c...004p0d.dat
If I got rid of T-Junctions, there would a huge amount of small, thin triangles around the border.
That part doesn't seem to suffer from the problem indeed, but it has only 4 quads introducing t-junctions (the side frame).
So it would only need 14+14+4+4=36 extra quads to be completely t-junction free.
But in the end it's all on a very small surface so you might be right about it not be 'worth' it for such parts.