Howto treat submodel as inlined in LPub3D

[Lutz Gehlen]

Does the attached model achieve what you are aiming for?

It shows;

1. two bricks as a sub-model done as a callout then
   
2. placed on a single brick. Followed by
   
3. the same sub-model (but ignored) and then
   
4. using the LPUB PLI BEGIN SUB command twwice to insert the two parts from the ignored sub-model
   
5. with a single brick, to list the three bricks in the part list
   
6. the bill of materials at the end is correct.
   

David

Hi David,

very interesting, I would never have thought of such an approach. Yes, I think it does achieve what I am aiming for. I am not sure whether I want to apply it large scale, but it's certainly an eye-opener.

Thank you,
Lutz