Sticker with other than rectangular shape

[Jaco van der Molen]

Philippe Hurbain

Perhaps I will create it wit LDraw geometry since I am learning that too.

Definitely, a flat sticker with simple geometric pattern like this one should be done using LDraw geometry. It's another story if the pattern is complex, or if the sticker is not flat. In the later case, even for simple patterns, both methods have benefits and drawbacks. LDraw geometry is crisper but can look faceted, and yields surface smoothing artifacts. Texmap (with reasonably sized images) look a bit fuzzy, but smoothing looks as good as unpatterned shape.

Progress so far: https://drive.google.com/open?id=1Fbv-Pz...5GljS0qKrL (has some errors to be fixed)

Extremely nice BIs!!!



Thanks!
I made some progress again and created the stickers for the bucket with LDraw geometry.
https://drive.google.com/open?id=1Fbv-Pz...5GljS0qKrL

@Philo: are you perhaps willing to create the geometry for the sticker on the technic panel, like you did for EV3?

The image is made.