Sticker with other than rectangular shape

[Jaco van der Molen]

It does not work. What is wrong here?

It works for me but its only visible from one side and seems a bit wrangled.

The coordinates look off (especially the scientific notation ones)

I cleaned it a bit up and added a backside and partial sides:

Code:

0 Set 42061 - Sticker 1
0 UNOFFICIAL PART
0 BFC CERTIFY CCW

0 !TEXMAP START PLANAR   -37 0 0   37 0 0   -37 0 -47   42061stk01.png
1 16   0 0 -10    36 0 0      0 -1 0       0 0 -27    48/2-4disc.dat
4 16   36 0  0    36 0 -10   -36 0 -10    -36 0  0
0 !TEXMAP END


0 BFC INVERTNEXT
1 16   0 -1 -10    36 0 0      0 -1 0       0 0 -27    48/2-4disc.dat
4 16   -36 -1  0   -36 -1 -10   36 -1 -10  36 -1  0  
1 16   0 0 -10    36 0 0      0 -1 0       0 0 -27    48/2-4cyli2.dat

edit: Changed some 37's into 36's

OK, works now for me too. It seems to project the image on the back?
As can see in the screenshot below the image is not visable in the part bin if the part is drawn at this angle.

The thickness of a sticker is 0.25 LDU, right?
So the 2-4cyli2 you added should be 0.25 high.
And I think we can use the box4-1.dat primitive to close things up, right?

   

We're getting close, though the form is not right too and the sticker is too small at the rectangular part.

The reason I am going through all this effort is that I am trying to recreate the original instructions for the set with LPub3D as much as possible.
Progress so far: https://drive.google.com/open?id=1Fbv-Pz...5GljS0qKrL (has some errors to be fixed)