RE: Lpub 3d not showing PIL object
2018-11-07, 17:40 (This post was last modified: 2018-11-07, 17:41 by Johann Eisner.)
2018-11-07, 17:40 (This post was last modified: 2018-11-07, 17:41 by Johann Eisner.)
Hi
I still use MLCad as editor and that's the way it works best.
I simply import the part in a submodell and then paste it as a part.
This always worked without any detours.
Regards Johann
I still use MLCad as editor and that's the way it works best.
I simply import the part in a submodell and then paste it as a part.
This always worked without any detours.
Regards Johann
If nothing goes right, go left.