Part request 4150px21

[Jaco van der Molen]

Jaco van der Molen
[quote pid='29393' dateline='1537350396']

Best done with texture mapping then?
If there is a high res picture or very good photo or scan it can be done.

Yeah, gradients
And beeing silver printed, not sure that texmap will provide a good result. Anyway, here is a pretty good image I found:

[/quote]

OK, I can try to redraw it in my graphics program (Fireworks).
As you might know and remember it works with vector graphic information but can write bitmap PNG files.
You can use all sorts of lines, colors and gradients to get very good results.
I'll give it a try.

Here is an attempt to approach and mimic the pattern

   

Perhaps this is usable to texture map the part?